R1HPL


Medium-pressure single-lip oil seal

Medium-pressure single-lip oil seal for press-in fitment in an open groove, retaining device required to hold seal in place under pressure

The thermoplastic reinforced design ensures concentric fitment and increased corrosion resistance over traditional seals.  A tight tolerance lip support ring ensures a flexible seal lip and enables this seal to operate at higher continuous operating pressure.  Optimized seal lip design uses a garter spring to maintain a constant radial lip load, thus ensuring optimum sealability. This seal is also available in small quantities for repairs and seal replacements within 1 to 3 days.  For dirty, dusty or polluted environments, our R2HP style with additional dust lip should be used.




Operating Range
MaterialContinuous PressureMax.Pressure SpikeTemperatureSurface SpeedDry-runPV-Rating
V101110psi (7.6bar)200psi (14bar)-4 to 392°F (-20 to 200°C)Up to 3,000 fpm (15m/s)NO2.7
N102110psi (7.6bar)200psi (14bar)-13 to 302°F (-25 to 150°C)Up to 2,100 fpm (10.5m/s)NO2.1
N101110psi (7.6bar)200psi (14bar)-13 to 212°F (-25 to 100°C)Up to 1,600 fpm (8m/s)NO1.4
Size Table (Inch)Standard sizes listed below are preferred sizes for new design applications; however, we offer any other seal size as required. Seals are available for any shaft diameter size in 0.001 inch increments, including Functional Range.
A
Shaft Diameter
CS
Cross-section
D
Bore Diameter
B Diameter
Tol. +/- 0.010
L
F
C
Chamfer
R1
Radius
Standard RangeFunctional RangeToleranceD=ToleranceB=Tol. +0.010/-0 min.max.
0.750-2.999"0.750 - 31.000"+/-0.0037/16A + 0.875+/-.001A + 0.1000.4500.383
0.040
0.020
3.000 - 5.999"0.750 - 31.000"+/-0.0041/2A + 1.000+/-.0015A + 0.2000.5120.4250.0900.030
6.000 - 13.999"1.000 - 31.000"+/-0.0055/8A + 1.250+/-.002A + 0.2000.6370.5300.1300.030
14.000 - 30.999"2.000 - 31.000"+/-0.0063/4A + 1.500+/-.003A + 0.2200.6370.5300.1500.030
31.000 - 63.000"
consult with AHPSeals engineering
*Standard cross-sections (CS) listed and non-standard sizes can be provided for any shaft size up to 63 inches. Seal retaining plate for pressures above 7 psi recommended. Surface finish: Shaft (A) plunge ground, zero lead, Ra 8-16µin for rubber seal lip, Ra 6-12µin for PTFE seal lip. Housing (D,L) Ra 32-63µin, shaft material hardness 55-65RC. See Technical Info for more specific information.

Seal Size Selector – Request a Quote

  • Enter shaft, rod or bore diameter
  • If recommended size is not feasible, please enter your preferred dimensions
  • If recommended size is not feasible, please enter your preferred dimensions
Back to Products page
Seal Housing Drawing