Single-Lip V-Spring-loaded rotary shaft seal for extreme environments.

VS-RS19B


Single-Lip V-Spring-loaded rotary shaft seal for extreme environments.

This seal is designed to provide long service life and low friction for extreme service applications over a wide temperature range.

This seal is for high PV applications characterized by high pressure and low speed.  This seal has a small cross section and is available in many materials specially suited to handle aggressive chemicals and environments.  Also available in small quantities for repairs and seal replacement in 1 to 3 days.




Operating Range
MaterialContinuous PressureMax.Pressure SpikeTemperatureSurface SpeedApplicationDry-runPV-Rating
Permachem 62333,000psi (210bar)3,500psi (240bar)-58 to 400°F (-50 to 200°C)Up to 1,200 fpm (6m/s)standard oil lubrication, high waterbased fluidsYES9
Permachem 62353,000psi (210bar)3,500psi (240bar)-58 to 400°F (-50 to 200°C)Up to 1,200 fpm (6m/s)Soft shaft material, gaseous media, FDA compliantYES9
Duraloy 47363,000psi (210bar)3,500psi (240bar)-58 to 400°F (-50 to 200°C)Up to 1,200 fpm (6m/s)low wear and abrasion, long service lifeYES9
Size Table (Inch)Standard sizes listed below are preferred sizes for new design applications; however, we offer any other seal size as required.Seals are available for any shaft diameter size in 0.001 inch increments without tooling charges, including Functional Range.
A
Shaft Diameter
CS
Cross-section

D
Bore Diameter
B
Diameter
**
Tolerances
L
S
C
R
Radius
Standard RangeFunctional RangeTolerance*D=B=D, BTol.+0.005/-0 max.
0.125 - 0.874"
0.125 - 3.000"
+0/-0.0023/32 A + 0.187A + 0.006+0.002/-00.3000.0700.0250.015
0.875 - 1.674"0.330 - 3.750"+0/-0.0021/8A + 0.250A + 0.008+0.002/-00.3900.0900.0300.015
1.675 - 4.999"0.860 - 5.000"+0/-0.0023/16A + 0.375A + 0.012+0.002/-00.5150.1100.0600.015
5.000 - 9.249"1.350 - 9.500"+0/-0.00251/4A + 0.500A + 0.016+0.003/-00.6400.1400.0800.015
9.250 - 18.000"3.750 - 18.000"+0/-0.0035/16A + 0.625A + 0.020+0.004/-00.6400.1500.1100.015
18.001 - 63.000"consult AHPSeals engineering
*Standard cross-sections (CS) listed and non-standard sizes can be provided for any shaft size up to 63 inches. **For pressure above 3,000 psi or temperature above 200°F, contact engineering for clearances. Surface finish: Shaft (A) plunge ground, zero lead Ra 6-12µin Housing (D,L) Ra 16-32µin. Shaft material hardness 55-65RC. See Technical Info for more specific information.

Seal Size Selector – Request a Quote

  • Enter shaft, rod or bore diameter
  • If recommended size is not feasible, please enter your preferred dimensions
  • If recommended size is not feasible, please enter your preferred dimensions
Back to Products page
Seal Housing Drawing