VS-Series High Pressure & Special Designs Archives - AHP Seals

Showing all 6 results

VS-K19HP1
VS-K19HP1
High-Pressure V-Spring Piston Seal

High-pressure piston seal with active back-up ring, sealing pressure up to 10,000psi*(690bar). When the seal is pressurized, the back-up ring will close the radial seal extrusion gap, allowing the seal to operate under high pressure without extruding. This seal design can accommodate shorter seal heights than other high-pressure seal designs.

Compare
VS-PRS19DS
VS-PRS19DS
Large section V-Spring Rod or Piston Seal

For use as either rod or piston seal in dynamic sealing application with large radial seal cross-section and deflection range. Chamfered seal lips provide for easy installation and better lubrication in dynamic sealing applications, resulting in extended seal and mating surface hardware life.

Compare
VS-PRS19HP
VS-PRS19HP
High-Pressure V-Spring Rod or Piston Seal

High-pressure rod or piston seal with contoured back-up ring sealing pressure up to 10,000psi*(690bar) and beyond . When the seal is pressurized, the contoured back-up ring will close the radial seal extrusion gap, allowing the seal to operate under high pressure without extruding. This seal is suited to applications where extrusion can take place at both OD and ID.

Compare
VS-PRS19HP2
VS-PRS19HP2
High-Pressure V-Spring Rod or Piston Seal

High-pressure rod or piston seal with wedged back-up rings sealing pressure up to 10,000psi*(690bar). When the seal is pressurized, the wedged back-up rings will close the radial seal extrusion gap, allowing the seal to operate under high pressure without extruding.

Compare
VS-PRS19M
VS-PRS19M
Multi-lip V-Spring Rod or Piston Seal

For use as either rod or piston seal in slow dynamic and static sealing applications that require redundant sealing lips. Multi-lip and spring design delivers better sealing performance under low and high pressure. Also available in scraper-lip design for abrasive media.

Compare
VS-S19HP1
VS-S19HP1
High-Pressure V-Spring Rod Seal

High-pressure rod seal with active back-up ring, sealing pressure up to 10,000psi*(690bar). When the seal is pressurized, the back-up ring will close the radial seal extrusion gap, allowing the seal to operate under high pressure without extruding. This seal design can accommodate shorter seal heights than other high-pressure seal designs.

Compare